The Intelix DIGI-HD60C-R HDBaseT HDMI Receiver handles HDMI, bi-directional IR, bi-directional RS232 and Ethernet over a single twisted pair cable.
Leveraging HDBaseT technology for enhanced transmission over shielded and unshielded twisted pair cabling, the DIGI-HD60C-R
features power over HDBaseT (PoH), allowing flexible power on either the transmitter or receiver. Plus, other compatible PoH devices will power or be powered by the DIGI-HD60C-R.
The DIGI-HD60C-R supports 1080p, and 3D video up to 60 meters (195 feet). 4K x 2K up to 35 meters (115 feet). Built-in surge protection and diagnostic LEDs ensure hassle-free and robust installations. The system is HDMI v1.4 compliant, so it handles advanced HDMI video formats, including (but not limited to) 1080p, 4K, 2D, 3D, 120Hz, 240Hz, along with up to PCM 8 channel, Dolby Digital TrueHD, and DTS-HD Master Audio lossless audio formats.
Use with any of these Intelix HDBaseT transmitters:
Since the system can be powered from either the transmitter or the receiver end of the run, a power supply is not included, but you will need at least one power supply per run. In addition, some Intelix distribution systems are capable of supplying power from the head unit, in which case an additional power supply would not be required. If you need a power supply, you may add it to your cart below.
As with virtually all systems that are based upon twisted-pair cable technology, the Intelix DIGI-HD60C-R HDBASET HDMI Receiver will work with virtually any twisted-pair cables, including Cat-5e and Cat-6, but range and bandwidth is directly related to both distance and cable quality, so to get the highest resolutions at the greatest distances, you will want high-quality, low-skew cables. If you want the very best pre-terminated cables, please consider our VideoTwist cables.
Like most Intelix products, the DIGI-HD60C-R comes with a two year limited warranty from the manufacturer.
The Intelix DIGI-HD-60C extends HDMI, IR, and RS232 over a single twisted pair cable. The DIGI-HD-60C
supports a 1080p video signal up to 60m, as well as 3D and 4K x 2K signals up to 35m.
Built-in surge protection and diagnostic LEDs ensure hassle-free and robust installations. Flexible power design allows the units to be powered at either the TX or RX end, and only one power supply is required. The power supply (PS-24D-25) and IR accessories (DIGIB-EMT and DIGIB-EYE) are sold separately.
The DIGI-HD60-R is designed for use only with Intelix branded HDBaseT products and other HDBaseT products which conform to the reference circuit design. The power circuit may not be compatible with other HDBaseT devices and may damage them.
Distances and picture quality may be affected by cable grade, cable quality, source and destination equipment, RF and electrical interference, and cable patches. Intelix specifications are based on straight-through cabling with standard-grade Cat 5e unless noted otherwise.
The front-right perspective of the receives is shown in this photo.
This photo shows the left side panel..
The right side panel is shown here.
This is the spec sheet for the DIGI-HD60C series, in PDF format.
Here is the Installation Manual for the DIGI-HD60C series, in PDF format.
Design excellence, high quality materials, meticulous workmanship, and superior service...put it all together and you get a superior product. Don't get stuck with bad advice, poor service, slow shipment or an inferior product. If you want the best, here it is.